AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Adding i2c u boot commands11/21/2023 ![]() Linux Framebuffer drivers for small TFT LCD display modules. If you need touch screen support, add this module to your /etc/modules Ln -sf /boot/bin/bananapilcd5.bin /boot/script.bin Ln -sf /boot/bin/bananapilcd7.bin /boot/script.bin valid command in uboot is i2c mw 0x50.0 AA 1 >times of reading. Image has pre-loaded settings for two LVDS display. So you could use ‘mw’ to setup an area of memory with the right contents or even hexedit a file on your host and then load the file to memory, write the memory to EEPROM. Test – display some picture on the screen:įbi -d /dev/fb2 -T 1 -noverbose -a yourimage.jpgĬurrently working only under Legacy kernel.Currently working only under Legacy kernel.įbtft_device name=adafruit22a rotate=90 speed=48000000 fps=50 gpios=reset:25,led:19,dc:24 I am using 2.4″ 240×320 SPI TFT LCD Serial Port Module+5/3.3V Pbc Adapter Micro SD ILI9341.I am using this code for mainline kernel and with changed line: /dev/i2c-%u = /dev/i2c-2 for Legacy kernel. ![]() It’s a standard Hitachi HD44780 based 20×4 LCD, wired and tested according to wiringBP example. I didn’t took a picture of the third one. All of them are working perfectly with my image. I tried three different display connection types: I2C, (4bit) parallel and SPI. Remember to recompile boot.cmd to boot.scr and note that changes will come into action after second boot. You can do this by adding saveenv command at the end of boot script (boot.cmd). Defaults to overscan_x=32 and overscan_y=20 for composite monitors, 0 for other monitors.įor example to always use the HDMI connector, even if no cable is inserted, using edid info when available and otherwise initalizing it at use: setenv video-mode regarding video must be saved into U-Boot environment file since they must be read before reading boot script. top and bottom to deal with overscanning displays. This configures a black border on the left and right resp. Overscan_x/overscan_y= - Set x/y overscan value If valid EDID info was read from the monitor the EDID info will overrides the xres, yres and refresh from the video-mode env. This configures how long to wait for the HPD signal before assuming no cable is connected.Įdid= - Enable use of DDC + EDID to get monitor infoġ: Enabled. When the monitor and the board power up at the same time, it may take some time for the monitor to assert the HPD signal. Hpd_delay= - How long to wait for the HDMI HPD signal in milliseconds Fallback to the LCD / VGA / none in that order (if available) Configure DVI/HDMI output even if no cable is detectedġ: Enabled. ![]() Hpd= - Enable use of the HDMI HotPlug Detect featureĠ: Disabled.
0 Comments
Read More
Leave a Reply. |